36 VOLT 90 AMP OUTPUT FORKLIFT CHARGER SINGLE PHASE INPUT 220/240 20 AMPS

Description

Main features: NEW
Solid State SINGLE PHASE FORKLIFT CHARGER
New vertical case for better ventilation and cooling
Customizable in terms of: battery type, charging voltage, charging current, charging curves
Possibility to download the information of the last 300 charging cycles via USB port (HF View software)
Other FEATURES
Size 18 ½ long 13 ½ wide and 6 1/2 deep.
36V – 90A to battery
New Design for better thermal performances
High-frequency switching technology Active PFC
Very low output ripple High efficiency over 90%
Suitable both for acid-lead, sealed and gel traction batteries. Microprocessor controlled charge process.
Standard charging cuNes: IUla, IUUo, IUIU, lua, luo, other special charging cuNes are customizable.
Possibility to change any parameter or the whole charging cuNe
Simultaneous visualization, on a graphic display, of the following data:
•
1. Charging
current
•
2. Battery
voltage
•
3. Amper-hours absorbed by the
battery
•
4
.
Time of the charge
cycle
•
5
.
Charging
profile
Display visualization in alphanumeric form of potential error messages
Compensation of the voltage drop on the connection cables at the battery.
Charge process starting in the
"soft
start" modality and automatic reset in case of a new battery insertion.
Charge process starts also with 2V batteries. Output protection against short-circuit.
Protection against polarity inversion. Programmable via USB port or via display.
Possibility to download the information of the last 300 cycles via USB port.
Frontal HOST USB port to load/modify configurations through USB stick in one click.
AC Input Single Phase 220/240 20Amps
DC output 36 Volts 90 Amp
Notes:
Charger Cord Length is Approximately  9 foot plus Long connector for forklift.
Power Cord Is 8 foot Connector Not included
No Battery Connectors Included