Trailer Ramps-Mfg In The USA-5ft.L x 12in W 5,000 lb Cap. Pair - OFF SECONDS

Description

PLEASE NOTE
:
These ramps are brand new, never used. The ramps were nicked up during shipping and more than likely only one of the ramps were affected. See the second photo illustrating the typical damage to a few of the serrated cross rods. All  other aspects to the ramp are virtually flawless. Discounted .00.
ALSO  NOTE:
Stated shipping rates are for the
Continental United States
only. Please contact us for other shipping charges.
International shipping
is not available to all countries because of weight and length restrictions. Please check the requirements or as you process the transaction you'll be informed.
5' x 12" Aluminum Trailer Ramps - Pair
Model # 512 H5
Made in the
USA
These high quality ramps are manufactured by a company who has been in business for
35 years
. They stand behind their workmanship offering a one year warranty.
Photo illustrates the ramps connected to a trailer 15" off the ground
The two (2) ramps combined have a
5,000 lb
distributed loading capacity. Generally only one axle at a time is on the ramps, therefore easily handling any piece of equipment weighing less than 5,000 lbs. They are versatile allowing you to load pick-up trucks, autos, tractors, construction & landscape equipment onto a trailer.
.
The ramps are available either
arched
or
straight
or with angle or flat plate ends. We will reach out to you to clarify which ramps work best for your application.   And if we don't hear back from you we will send the advertised arched ramps with angle ends.
Welded on angle iron is used to secure the ramps to the trailer without worrying about the ramps sliding off while loading. You must have a lip or round bar behind your trailer for these ramps to work.
Alternative
- If the back of your trailer doesn't have a receiving means to hold the ramps in place when loading, these ramps are also available with flat plates on the end in place of the angle. This will allow you to load onto most flat surfaces. Please indicate you'd prefer the flat plates in a message to seller. We will acknowledge receipt of your message.
Application information
:
Arched and straight ramps have the same weight capacity. The arch is best for a low clearance deck with short wheel base, like a ride on lawn mower. The straight ramps are equally strong however they store a little easier because they lay flat.
If you can envision the straight and the arched side by side, the arched ramp goes up more steeply than the straight ramp solely so it can "rise into" the arch. The arch is primarily a benefit where the ramp attaches to the trailer, smoothing the angle created when a straight ramp touches a flat surface.
If choosing flat plate instead of angle - The flat plate and angle are equally strong. The flat plate is solid across the 12" width and is 3/8" thick, plenty strong. To prevent the plated ramps from sliding you can either drop a pin or use the provided tiedowns. You could also bolt an angle to the ramps' flat plate and use the ramps either way.
Ramp Specifications:
5,000 lb. distributed load capacity per pair.
All aluminum, 6005T5 alloy construction.
Each ramp is 5 ft. long by 12" wide and 2" thick (each).
The ramps are
lightweight
, each weighing only 15 lbs.
Serrated cross-rod design, spaced 3-1/2" apart for
excellent
traction.
To view other ramp options please visit our store page
Aluminum Ramps
.
Please contact us at call
856-374-4740
with any questions or comments.
Telephone customer service hours:
M-F 7am-9pm EST Sat. 7am-5pm